Type designation key
The type designation contains information on the specifications and configuration
of the drive. The first digits from left express the basic drive type. The optional
selections are given thereafter, separated by plus signs. The main selections are
described below. Not all selections are available for all types. For more information,
refer to the ordering instructions available separately on request.
￭ Basic code
DescriptionCode
Product seriesACS580
Type
The standard delivery includes: drive module to be installed in a cabinet, IP00 (UL Open Type),
bookshelf mounting with pedestal, integrated control unit (inside the drive module), Assistant
control panel ACS-AP-S and panel holder, build-in choke, extraction/installation ramp, full-
size output cable connection terminals, common mode filter (+E208), DPMP-03 mounting
platform, EMC filter for 2nd environment TN (grounded) and IT (ungrounded) systems (+E210),
no DC connection busbars, ACS580 standard control program, RS-485 Modbus RTU adapter
module (CEIA-01), Safe torque off function, coated boards, printed multilingual quick install-
ation and start-up guides.
-04
Note: In the US market, the standard offering differs, in that: the door mounting kit is the
DPMP-05-S, the control unit is external (+P906), the DC connection busbars (+H356) are in-
cluded, and the quick guide contains English language only.
Refer to section Option codes (page 40) for options.
Size
See the ratings table.-xxxxA
Voltage range
380…480 V AC. This is indicated in the type designation label as typical input voltage level
(3~ 400/480 VAC)
4
￭ Option codes
DescriptionCode
IP20 shrouds for cabling areaB051
Chemical gases contamination class 3C3 compliant drive according to IEC 60721-3-3:2002.
C219
Chemical gases contamination class C4 compliant drive according to IEC 60721-3-3:2019 and
ISO 9223.
Applies to ammonia only.
Brake choppersD150
Common mode filter (included as standard)E208
EMC filter for 2nd environment TN (grounded) or IT (ungrounded) system, category C3 (included
as standard)
E210
No standard wheeled pedestal. The drive module is equipped with a low pedestal to which
the bottom grille can be attached if IP20 degree of protection is needed from bottom. Requires
option +0P919.
0H354
No full size cable connection terminals for output power cables0H371
DC connection busbars (for US standard as default)H356
Full-size input terminals. Not to be used with full power cabling panels (option +H381).H370
40 Operation principle and hardware description
To Next Page
Loading...
