ABB ACS580-04 - Drive Module with Full Cabling Panels (Option +H381); Drive Module with IP20 Shrouds (Option +B051); Input Power Cable Connection Terminals (Option +H370) and Ground Busbar Assembly; Installation Alternatives

Installation alternatives
￭ Drive module with IP20 shrouds (option +B051)
For an installation example of the drive module with IP20 shrouds (option +B051) into
a Rittal VX25 enclosure including power cable connection procedure, see Installation
example of drive module with IP20 shrouds (option +B051).
￭ Drive module with full cabling panels (option +H381)
For an installation example of the drive module with full cabling panels (option +H381)
into a Rittal VX25 enclosure including power cable connection procedure, see
Installation example with full cabling panels (option +H381) (page 121).
Note: This installation alternative is not possible without pedestal (with option
+0H354).
￭ Input power cable connection terminals (option +H370) and ground
busbar assembly
Connect the input power cable connection terminals in the same way as the motor
cable connection terminals. Install the metallic shroud as shown below.
Combi screw M4×8
Torx T20 2 N·m
3AXD50000017460
Mechanical installation 67
10