ABB ACS580-04 - Replacing the Drive Module with Option +H381

1
2
1
2
9. Install the new module in reverse order to the above.
Replacing the drive module with option +H381
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Note: The replacement module must be of the same type as the original module: same
type code and same option codes.
Handle the drive module carefully:
• Use safety shoes with a metal toe cap to prevent foot injury.
• Lift the drive module only by the lifting lugs.
• Make sure that the module does not topple over when you move it on the floor:
To open the support legs, press each leg a little down and turn it aside (1, 2). When
possible, secure the module also with chains.
• Do not tilt the drive module. It is heavy and its center of gravity is high. The module
overturns from a sideways tilt of 5 degrees. Do not leave the module unattended
on a sloping floor.
Maintenance 173