ABB ACS580-04 - AI1 and AI2 as Pt100, Pt1000, Ni1000, KTY83 and KTY84 Sensor Inputs (X1); DI5 as Frequency Input; DI6 as PTC Input

An example of a three-wire sensor/transmitter supplied by the drive auxiliary voltage
output is shown below.The sensor is supplied through its current output and the drive
feeds the supply voltage (+24 V DC). Thus the output signal must be 4…20 mA, not
0…20 mA.
4…20 mA
+
-
P
I
...
AI2
AGND
+24V
DGND
OUT
￭ DI5 as frequency input
For setting the parameters for the digital frequency input, see the firmware manual.
￭ DI6 as PTC input
If DI6 is used as a PTC input, see firmware manual for how to set parameters
accordingly.
Note: If DI6 is used as a PTC input, the wiring and the PTC sensor need to be double
isolated. Otherwise the CMOD-02 I/O extension module must be used.
1
...
+24V
DI6
+t°+t°+t°+t°+t°
+t°
One to six PTC thermistors connected in series1
￭ AI1 and AI2 as Pt100, Pt1000, Ni1000, KTY83 and KTY84 sensor inputs
(X1)
Sensors for motor temperature measurement can be connected between an analog
input and output. An example connection is shown below. Leave the other end of the
shield unconnected or ground it indirectly via a few nanofarads high-frequency
capacitor, for example, 3.3 nF / 630 V. The shield can also be grounded directly at both
ends if they are in the same ground line with no significant voltage drop between the
end points.
...
AI1
AGND
AO1
AGND
2
1
3
TTT
1…3 sensor(s) of type Pt100 or Pt1000, or 1 sensor of type Ni1000/KTY83/KTY841
Control unit 141