ABB ACS580-04 - Unpacking the Delivery

The connectors at the drive module end are located behind the middle front cover.
M4×8 Torx T20
2 N·m (18 lbf·in)
ZPOW
BGDR
SOIA
Unpacking the delivery
The external control unit is delivered in a cardboard box inside the main drive module
package.
Unpack the external control unit package. Make sure that it contains these items:
• CCU-24 control unit
• mounting template.
The mounting template contains a mounting pattern for a CCU-24 control unit on one
side and a mounting pattern for a ZCU-14 control unit on the other side.
The control cables that will connect the external control unit to the drive module are
connected to the drive module for safe transit. ABB recommends that you disconnect
them before you install the drive module:
1. Remove the middle front cover of the drive module.
2. Disconnect the cables and carefully pull them out through the rubber grommet.
Wind the cables carefully into the supplied plastic bag for later installation.
150 External control unit (option +P906)