General safety in installation, start-up and maintenance
These instructions are for all personnel who do work on the drive.
WARNING!
Obey these instructions. If you ignore them, injury or death, or damage to the
equipment can occur.
• Keep the drive in its package until you install it. After unpacking, protect the drive
from dust, debris and moisture.
• Use the required personal protective equipment: safety shoes with metal toe cap,
safety glasses, protective gloves and long sleeves, etc. Some parts have sharp
edges.
• Lift a heavy drive with a lifting device. Use the designated lifting points. See the
dimension drawings.
• Obey the local laws and regulations applicable to lifting, such as requirements for
planning the lift, for capacity and condition of lifting equipment, and for training
of personnel. Incorrect lifting can cause danger or damage.
• Attach the drive cabinet to the floor to prevent it from toppling over. The cabinet
has a high center of gravity. When you pull out heavy components or power
modules, there is a risk of overturning. Attach the cabinet also to the wall when
necessary.
• Do not use the module extraction/installation ramp with plinth heights that exceed
the maximum allowed height.
• Attach the module extraction/installation ramp carefully.
• Make sure that the module does not topple over when you move it on the floor:
To open the support legs, press each leg a little down and turn it aside (1, 2).
Whenever possible attach the module also with chains. Do not tilt the drive module.
It is heavy and its center of gravity is high. The module overturns when tilted more
than 5 degrees. Do not leave the module unattended on a sloping floor.
18 Safety instructions
To Next Page
Loading...
Need help?
General
