Grounding busbar of the output power cabling panelD
Allowed space for power cables.E
The input and output power cables must fit inside the area marked with diagonal lines to prevent
chafing of the cables when the drive module is inserted into the cabinet.
Installing the drive module into the enclosure
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Handle the drive module carefully. Make sure that the module does not
fall down when moving it on the floor and during installation and
maintenance work: To open the support legs, press each leg a little
down and turn it aside (1, 2). When possible, also secure the module
with chains from top.
Do not tilt the drive module (A). It is heavy and its center of gravity is
high. The module will overturn from a sideways tilt of 5 degrees. Do
not leave the module unattended on a sloping floor.
￭ Installation procedure
1. Attach the mounting bracket to the drive module. The bracket will ground the
drive module to the cabinet frame.
Installation example with full cabling panels (option +H381) 125
To Next Page
Loading...
