Task (motor cables)Step
Connect the phase T2/V2 conductors to the T2/V2 connection terminal.7
Install the T1/U2 connection terminal to the insulators. See the warning in step 4.8
Connect the phase T1/U2 conductors to the T1/U2 terminal.9
Remove the plastic sheeting from the output clear plastic shroud from both sides.10
Install the shroud to the drive module.11
Install the lower front cover to the drive module.12
Task (input cables)Step
Ground the input cable shields (if present) 360° at the cabinet entry.1
Connect the twisted shields of the input cables and separate ground cable (if present) to the
cabinet grounding busbar.
2
Step drill carefully sufficiently big holes to the lead-through clear plastic shroud for the cables
to the connected. Align the holes in the vertical direction according to the alignment holes in
the shroud. Smooth the hole edges.
3
Remove the plastic sheeting from both sides of the shroud.
Attach the cables firmly to the cabinet frame to prevent chafing against the hole edges.
Put the conductors of the input cables through the drilled holes in the clear plastic shroud.4
For drive modules without option +H370: Connect the input cable conductors to the drive
module L1/U1, L2/V1 and L3/W1 connection busbars, Go to step 12.
5
For option +H370: Perform steps 6 to 11.
Screw in and tighten the insulators to the drive module by hand. Install the L1/U1 connection
terminal to the insulators.
6
WARNING!
Do not use longer screws or a larger tightening torque than specified in the in-
stallation drawing. They can damage the insulator and cause a dangerous voltage
to be present at the module frame.
Connect the L1/U1 conductors to the L1/U1 connection terminal.7
Install the L2/V1 connection terminal to the insulators. See the warning in step 5.8
Connect the L2/V1 conductors to the L2/V1 connection terminal.9
Install the L3/W1 connection terminal to the insulators. See the warning in step 5.10
Connect the L3/W1 conductors to the L3/W1 connection terminal.11
Install the lead-through clear plastic shroud. Install the front clear plastic shroud and upper
front cover. Remove the cardboard protective covering from the drive module air outlet.
12
Install the side and top clear plastic shrouds to the drive module.13
116 Installation example of drive module with IP20 shrouds (option +B051)
To Next Page
Loading...
