3. Pull the cables through the control unit assembly, so they appear in the opening
at the rear of the control unit. Do not pull the ground conductor through but leave
it outside of the assembly. Make sure that the cables are not against sharp edges
or bare live parts.
4. Connect the cables to their connectors on the ZBIB board.
Cables from drive mod-
ule
ZBIB connectorsView of ZBIB board
ZPOW
X3:1X3:1
X3:2X3:2
BGDR
X7 (STO 1)X7 (STO 1)
X8 (STO 2)X8 (STO 2)
SOIA
V10 (black)V1 (gray)
V20 (grey)V2 (black)
152 External control unit (option +P906)
To Next Page
Loading...
