• With top entry and top exit (options +H351 and +H353): Remove the shrouds and
door fan (see Replacing the door fan (frames R10 and R11) (page 141)). Undo the
mounting screws and pull the shrouds out.
4.
Remove the door fan mounting plate. See section Replacing the door fan (frames R10
and R11) (page 141).
5. Peel off 3 to 5 cm of the outer insulation of the cables above the cable entries with the
conductive sleeves for the 360° high-frequency grounding.
102 Electrical installation
To Next Page
Loading...
