ABB REB650 - IED Status for IEC 60870-5-103 I103 IED

12.23 IED status for IEC 60870-5-103 I103IED
12.23.1 Functionality
I103IED is a function block with defined IED functions in monitor direction. This
block uses parameter as FunctionType, and information number parameter is defined
for each input signal.
12.23.2 Function block
IEC10000292-1-en.vsd
I103IED
BLOCK
19_LEDRS
21_TESTM
23_GRP1
24_GRP2
25_GRP3
26_GRP4
IEC10000292 V1 EN
Figure 144: I103IED function block
12.23.3 Signals
Table 279: I103IED Input signals
Name
Type Default Description
BLOCK BOOLEAN 0 Block of status reporting
19_LEDRS BOOLEAN 0 Information number 19, reset LEDs
21_TESTM BOOLEAN 0 Information number 21, test mode is active
23_GRP1 BOOLEAN 0 Information number 23, setting group 1 is active
24_GRP2 BOOLEAN 0 Information number 24, setting group 2 is active
25_GRP3 BOOLEAN 0 Information number 25, setting group 3 is active
26_GRP4 BOOLEAN 0 Information number 26, setting group 4 is active
12.23.4 Settings
Table 280: I103IED Non group settings (basic)
Name
Values (Range) Unit Step Default Description
FunctionType 1 - 255 - 1 1 Function type (1-255)
1MRK 505 277-UUS C Section 12
Monitoring
341
Technical Manual