ABB REB650 - Binary Inputs

Table 362: Auxiliary voltage supply of 48-125 V DC
Case Terminal Description
3U full 19” X420-1 - Input
X420-2 + Input
16.2.3 Binary inputs
The binary inputs can be used, for example, to generate a blocking signal, to unlatch
output contacts, to trigger the digital fault recorder or for remote control of IED
settings.
Each signal connector terminal is connected with one 14 or 16 Gauge wire.
Table 363: Binary inputs X304, 3U full 19”
Terminal Description
PCM600 info
Hardware module
instance
Hardware channel
X304-1 Common - for inputs 1-3
X304-2 Binary input 1 + COM_101 BI1
X304-3 Binary input 2 + COM_101 BI2
X304-4 Binary input 3 + COM_101 BI3
X304-5 Common - for inputs 4-6
X304-6 Binary input 4 + COM_101 BI4
X304-7 Binary input 5 + COM_101 BI5
X304-8 Binary input 6 + COM_101 BI6
X304-9 Common - for inputs 7-9
X304-10 Binary input 7 + COM_101 BI7
X304-11 Binary input 8 + COM_101 BI8
X304-12 Binary input 9 + COM_101 BI9
X304-13 Common - for inputs 10-12
X304-14 Binary input 10 + COM_101 BI10
X304-15 Binary input 11 + COM_101 BI11
X304-16 Binary input 12 + COM_101 BI12
1MRK 505 277-UUS C Section 16
IED physical connections
419
Technical Manual