ADCMT 6244 - Page 198

6243/44 DC Voltage Current Source/Monitor Operation Manual
5.2.10 GPIB Code List
5-28
GPIB Block delimiter DL0 CR/LF, EOI *1
DL1 LF
DL2 EOI
DL? The block delimiter query command
The response is DL...
String delimiter SL0 Comma “,” *1
SL1 Space “ “
SL2 CR/LF
SL? The string delimiter query command
Responds with: SL...
Header output OH0 OFF
OH1 ON *2
OH? The header output query command
Responds with: OH...
Service request S0 ON
S1 OFF *1
S? The service request query command
The Responds with S...
Status *STB? The status byte register query command
*SRE Sets the service request enable register. *SREddd (0 to 255) 0 *2
*SRE? The service request enable register query command
*ESR? The standard event status register query command
*ESE Sets the standard event status enable register *ESEddd (0 to 255) 0 *2
*ESE? The standard event status enable register query command
DSR? The device invent register query command
DSE Sets the device invent enable register DSEddddd (0 to 65535) 0 *2
DSE? The device invent enable register query command
ERR? The error invent register query command
*CLS Clears the event register.
OPC *OPC Sets the SESR LSB after all operations are completed.
*OPC? Returns ASCII 1 after all operations are completed.
*WAI Pauses all operations before termination.
Table 5-5 GPIB Command List (8 of 9)
Item Command Description Default
Operation
During DC/
PLS operation
During sweep
operation