6243/44 DC Voltage Current Source/Monitor Operation Manual
3.3.7 MENU key (Setting Parameters)
3-11
Remote Sensing Switches between 4-wire connection and 2-wire connection.
2 Wire: 2-wire connection
At this time, 4 WIRE lamp is OFF.
4 Wire: 4-wire connection
At this time, 4 WIRE lamp is ON.
Limit/OSC Buzzer Selects whether or not the buzzer sounds (ON or OFF) when lim-
iter, reverse polarity source or oscillation is detected.
ON: The buzzer sounds when limiter, reverse polarity
source or oscillation is detected.
OFF: The buzzer is OFF.
3.3.7.4 MEASURE (Measurement Parameters)
Selecting MEASURE and pressing the key enables selection of parameters related to measurement.
Integration Time Selects the integration time of the AD converter.
Select the integration time from 500 s, 1 ms, 10 ms, 1 PLC, 10
PLC, and 100 PLC.
Auto Zero Toggles the Auto Zero function between ON and OFF.
ON: Cancels the measurement zero point drift one time
approximately every 10 seconds.
At this time, the AZERO indicator is ON.
OFF: Sets the Auto Zero function to OFF.
At this time, the AZERO indicator is OFF.
Resolution Selects the measurement resolution.
5-1/2 digits: Measurement with 5-1/2-digit resolution
4-1/2 digits: Measurement with 4-1/2-digit resolution
Measure Toggles measurement between ON and OFF.
ON: Measurement is performed.
OFF: Measurement is not performed.
Display Toggles display of the measured data and display of the source
value during sweep between ON and OFF.
ON: Measured data and source value during sweep are
displayed.
OFF: Measured data and source value during sweep are
not displayed.
To Next Page
Loading...
Need help?
General
