7352 Series Digital Multimeter Operation Manual
6.6.3 ADC Command Reference
6-20
Measure-
ment
Measured data
memory
IRNO? Reads the stored data range.
Reply:IRNO ddddd, ddddd(Single measurement mode)
IRNO 0dddd, 0dddd(Dual measurement mode)
(If the stored data does not exist:
IRNO 00000, -0001)
–
ICL Clears the measurement data memory. –
Trigger
system
Start INI Leaves the IDLE state. –
Continue INIC0 CONTINUOUS OFF –
INIC1 CONTINUOUS ON –
INIC? Reply: INIC0 or INIC1 –
Trigger abort ABO Forcibly moves to the IDLE state. –
Trigger source
selection
TRS0 IMMEDIATE –
TRS1 MANUAL –
TRS2 EXTERNAL (7352A) –
TRS3 BUS –
TRS? Reply: TRS0 to TRS3 –
Trigger delay TRDn n: 0 to 3600 (seconds)
*2
(0) –
TRD? Reply: TRDd.ddddEdd
(The position of the decimal point is different depending
on the setting.)
*2
–
Each trigger
delay for the
right and left
displays
TDE0 OFF –
TDE1 ON –
TDE? Reply: TDE0 to TDE1 –
Trigger count TRNn n:1 to 50000 (counts) (1) –
TRN? Reply: TRNddddd –
Sampling count
(by one trigger)
SPNn n:1 to 16000 (counts) (1) –
SPN? Reply: SPNddddd –
*2: This command is valid for the 2nd display setting only when TDE1 is set.
Item
Command
Description
Va l i d
command
for the 2nd
display
setting
Initial
value
R6452
To Next Page
Loading...
Need help?
General
