ADCMT 7352A - Page 143

7352 Series Digital Multimeter Operation Manual
6.6.4 SCPI Command Reference
6-39
Calculation PASS condition
range setting
:CALCulate:LIMit:PASS:LOWer
{ON,1|OFF,0}
ON, 1: Calculation result LOW is specified as the
PASS condition.
OFF, 0: Calculation result LOW is not specified as
the PASS condition.
:CALCulate:LIMit:PASS:LOWer? Reply: 1 or 0
:CALCulate:LIMit:PASS:MED
{ON,1|OFF,0}
ON, 1: Calculation result GO is specified as the
PASS condition.
OFF, 0: Calculation result GO is not specified as
the PASS condition.
:CALCulate:LIMit:PASS:MED? Reply: 1 or 0
:CALCulate:LIMit:PASS:UPPer
{ON,1|OFF,0}
ON, 1: Calculation result HI is specified as the
PASS condition.
OFF, 0: Calculation result HI is not specified as the
PASS condition.
:CALCulate:LIMit:PASS:UPPer? Reply: 1 or 0
Statistical
calculation
:CALCulate:STATistics
<int>,<int>[,(@<ch>)]
Specifies the calculation range and performs the
calculation.
<int>: 0 to 19999
0, -1
:CALCulate:STATistics? [(@<ch>)] Reply: dddd,dddd
:CALCulate:STATistics:COUNt? [(@<ch>)] Reads the number of samples.
Reply: +d.dddddE+dd
:CALCulate:STATistics:MAXimum?
[(@<ch>)]
Reads the maximum value.
Reply: d.dddddE+dd
:CALCulate:STATistics:MINimum?
[(@<ch>)]
Reads the minimum value.
Reply: d.dddddE+dd
:CALCulate:STATistics:AVERage?
[(@<ch>)]
Reads the average value.
Reply: d.dddddE+dd
:CALCulate:STATistics:DEVIation?
[(@<ch>)]
Reads the standard deviation.
Reply: d.dddddE+dd
:CALCulate:STATistics:MAXMin?
[(@<ch>)]
Reads the “maximum value - minimum value.”
Reply: d.dddddE+dd
Calculation
between 2 mea-
surements
:CALCulate:DDISplay
{OFF|ADDition|SUBTraction|MULTiply
|DIVision}
Performs the calculation between 2 measurements.
OFF: Calculation OFF
ADDition: Measurement for 1st display +
Measurement for 2nd display
SUBTraction: Measurement for 1st display -
Measurement for 2nd display
MULTiply: Measurement for 1st display *
Measurement for 2nd display
DIVision: Measurement for 1st display /
Measurement for 2nd display
NOTE: Valid only when the 2nd display is ON.
:CALCulate:DDISplay? Reply: OFF, ADD, SUBT, MULT, DIV
*1: <function>: Specify a function of “measurement function”, but do not enclose in double quotes.
Item SCPI command
Description
Initial
value