7352 Series Digital Multimeter Operation Manual
6.6.4 SCPI Command Reference
6-40
4. System relevant command
Item SCPI command
Description
Initial
value
System 2nd display
:DISPlay:WINDow2:STATe {ON,1|OFF,0}
ON, 1: ON
OFF, 0: OFF
NOTE: Valid only when the 2nd display is ON.
:DISPlay:WINDow2:STATe?
Reply: 1 or 0
Measurement
data display
:DISPlay {OFF,0|ON,1}
ON, 1: ON
OFF, 0: OFF
:DISPlay?
Reply: 1 or 0
Output data
:FORMat:READing:MCHannel
{BOTH|1|2}
BOTH:1st and 2nd displays
1: Only the 1st display
2: Only the 2nd display
NOTE: Valid only when the 2nd display is ON.
:FORMat:READing:MCHannel?
Reply: BOTH, 1, or 2
Buzzer
:CALCulate:LIMit:BEEPer
{OFF|FAIL|PASS}
OFF: OFF
FAIL: The buzzer sounds when the comparator cal-
culation result is FAIL.
PASS: The buzzer sounds when the comparator
calculation result is PASS.
:CALCulate:LIMit:BEEPer?
Reply: OFF, FAIL, or PASS
:SYSTem:BEEPer:STATe {ON,1|OFF,0}
ON, 1: Buzzer ON
OFF, 0: Buzzer OFF
:SYSTem:BEEPer:STATe?
Reply: 1 or 0
Power supply
frequency
[:SENSe]:LFRQency?
Reply: 50 or 60
Initialization
*RST
Parameter initialization
Device informa-
tion
*IDN?
Reply: ADC Corp., 7352X nnnnnnnnn, mmm
nnnnnnnnn: Serial number
mmm: Revision number
Output data
element specifi-
cation
:FORMat:ELEMents {DDISplay|NONE}
DDISplay:Specifies the calculation output between
2 measurements.
NONE: No output
:FORMat:ELEMents?
Reply: DDIS or NONE
Block delimiter
:SYSTem:GPIB:DELimiter:BLOCk
{CRLF|LF|EOI}
CRLF: CRLF+EOI
LF: LF
EOI: EOI
:SYSTem:GPIB:DELimiter:BLOCk?
Reply: CRLF, LF, or EOI
To Next Page
Loading...
Need help?
General
