ADCMT 7352A - Page 207

7352 Series Digital Multimeter Operation Manual
8.9 System Recovery Procedure
8-21
GPIB input output
buffer
Empty Empty Empty Empty Empty
Block delimiter CR/
LF+EOI
CR/
LF+EOI
CR/
LF+EOI
CR/LF+EOI CR/
LF+EOI
Memory readout
range
0,0 0,0 0,0 0,0 0,0
SRQ OFF OFF OFF OFF
Display ON/OFF ON ON ON ON ON
Calibration mode OFF OFF OFF OFF
Status register
QEER
00 0
Status register
OEER
00 0
Status register
SESER
00*2
Status register
MEER
00 0
Status register SRER 0 0 *2
Status register QER 0 0 0 0
Status register STB 0 0 0 0
Status register OER 0 0 0 0
Status register SESR 0 0 0 0
Status register MER 0 0 0 0
Error queue Empty Empty Empty Empty
Blank: No Action
Saved value: Last setting value when the power is turned off.
*2: By setting the *PSCn command
Table 8-5 Initial Values of Setting Parameters (3 of 3)
Parameter
Left side
display
Right side
display
When
shipping
Selecting
DFLT
from INIT
in MENU
Selecting
P.OFF from
‘P.ON.LD’
‘LOAD’ in PARAM *RST *CLS DCL