R3131 Spectrum Analyzer Operation Manual
No.
Title
Page
1-1
Operating Environment
1-4
1-2
Replacing the Power Fuse
1-6
1-3 Power Cable
1-7
1-4 Connecting the Power Supply Cable
1-8
1-5 Screen Display after Self Tests have Completed
1-9
1-6 Self Test Screen
1-9
1-7 Screen Shown after Executing Self Test
1-10
1-8 Removing the Display Filter
1-11
2-1 Front Panel
2-1
2-2 Screen Annotation
2-10
2-3
Rear Panel
2-12
2-4 Factory Defaults Screen
2-18
2-5
Calibration Signal Output Screen
2-18
2-6 Active Area Display
2-19
2-7 Setting the Center Frequency
2-19
2-8 Measuring Settings Screen
2-20
2-9 Peak Search Display Screen
2-21
2-10 Frequency Difference Between the Peak Point and a Point 3 dB Levels Down
2-22
2-11 Frequency Difference Between the Peak Point and a Point 60 dB Levels Down
2-22
2-12 Factory Defaults Screen
2-23
2-13 Calibration Signal Output
2-24
2-14 Measuring Settings Screen
2-24
2-15 Activating the Display Line
2-25
2-16 Making a Comparison Between Peaks Using Reference Lines
2-26
2-17 Screen Display Showing the Measuring Window
2-27
2-18
Screen Display after Zoom In
2-27
2-19
Factory Defaults Screen
2-28
2-20 Calibration Signal Output Screen
2-29
2-21 Measuring Settings Screen
2-29
2-22
Frequency Counter Measurement (Resolution: 1 kHz)
2-30
2-23
Frequency Counter Measurement (Resolution: 10 Hz)
2-30
2-24 Screen Display Prior to Auto Tuning
2-31
2-25 Screen Display after Auto Tuning
2-32
2-26 Signal Tracking Screen
2-34
2-27 Continuous Peak Search Screen
2-35
2-28 Measuring Settings Screen
2-37
2-29 Screen with UNCAL Message
2-37
2-30
Normal Measurement Screen
2-38
2-31 Setup for Measuring Two Signals Separately
2-39
2-32 Two Superimposed Peaks
2-40
2-33 Two Discernible Peaks
2-41
2-34 Two Distinct Peaks Can Now Be Seen
2-41
2-35 Setup for Verifying the Dynamic Range
2-42
2-36
Screen Display Prior to Changing the RBW
2-43
2-37 Screen Display after Changing the RBW
2-44
LIST OF ILLUSTRATIONS
F-1
To Next Page
Loading...
Need help?
General
