R3131 Spectrum Analyzer Operation Manual
1.5 Cleaning, Storing and Transporting the Analyzer
1.5 Cleaning, Storing and Transporting the Analyzer
1.5.1 Cleaning
Remove dust from the outside of the spectrum analyzer by wiping or brushing the surface with a soft cloth
or small brush. Use a brush to remove dust from around the panel keys. Hardened dirt can be removed by
using a cloth which has been dampened in water containing a mild detergent.
CAUTION:
I. Do not allow water to get inside the spectrum analyzer.
2. Do not use organic cleaning solvents, such as benzene, toluene, xylene, acetone or similar compounds, since
these solvents may damage the plastic parts.
3. Do not use abrasive cleaners.
• Cleaning the Display Filter
Normally cleaning the display filter from the front should be sufficient. However, if necessary, the fil-
ter itself can be detached from the spectrum analyzer by removing the two screws on the front. Clean
the backside of the filter with a soft cloth.
CAUTION: Do not touch the LCD display with your finger when the filler has been removed.
Remove the two screws to
detach the filter from the
spectrum analyzer.
Figure 1-8 Removing the Display Filter
To Next Page
Loading...
Need help?
General
