R3131 Spectrum Analyzer Operation Manual
2.4.2 Saving or Recalling Data
2.4.2 Saving or Recalling Data
(1) Saving Data
Data which can be saved to internal memory or to a floppy disk include the following:
• measurement conditions
• 501-point trace A (or B), or trace data for both A and B
NOTE: Trace data can be saved in Write or View mode only.
• The level values for trace data (Floppy disk only)
• Antenna correction data (Floppy disk only)
• Normalize deta (Available only when equipped with Option 74)
To save data, use the following procedure:
1. Press SHIFT and RECALL(SAVE).
The Save menu and the file list are displayed.
2. Press Device RAM/FD.
This selects either RAM (internal memory) or FD (floppy disk) as the file desti-
nation.
CAUTION: FD cannot be selected if a floppy disk is not present in the floppy disk
drive.
ADVANTEST R3131 Wed 10 Dec 1997
REF 0.0 dBm ATT 10dB A_wrt B_Plnk
SAVE FILE
FRE00
-
CENTERCENTER 30.00 MHz SPAN 20.00 MHz
RBW 300 kHz VBW 100 kHz SWP 50 ms
FILE LIST (FD:/SVRCL,
<FILE00. DAT>
**********
RW 0 Bytes
Setup: OFF
Trace: OFF
Ant : OFF
Norm : OFF
Save
Save
Save
Item
Protect
Delete
Device
RAM / FD
Figure 2-84 Screen Display Showing Floppy Disk as the Destination
2-88
To Next Page
Loading...
Need help?
General
