14 Safety
4510001 REV B – 220620
• Pay close attention to and understand all warning labels on the machine and follow safe
operating practices.
• The equipment generates heat and fumes when in operation. Be sure that the area is
properly ventilated.
• Keep water away from the Electrical Enclosure, the HMI, and all other electrical
components.
• Always replace Fuses and other protective circuit devices with those of the appropriate
current rating.
• Always wear Safety Glasses with side shields when working with glass containers.
• Some shrink label film contains toxic chemicals. Store and dispose of properly.
• Only use the E-Stop Button to shut off the LX-150 during actual emergencies. Routine
use of the E-Stop Button can damage the machine and void the warranty.
• Service and maintenance beyond what is described in this User Guide should be
performed by a trained and qualified technician. If in doubt, contact AFM or your
authorized distributor.
• Use proper lifting techniques when lifting heavy rolls of labels.
• This machine is protected by hardware Master Control Relay (MCR) and E-Stop and
door safety interlocks. Under no circumstances should these be disabled.
• Do not attempt to modify the machine or software in any way. Doing so may result in
damage to the machine, may void the warranty, or may cause serious injury.
• All operators must strictly observe these guidelines and ensure that the LX-150 is
properly maintained. Failure to do so may result in damage to the machine, may void the
warranty, or may cause serious injury.
To Next Page