AFM LX-150 - Software; Software Navigation and Controls

Software 77
4510001 REV B - 220620
Software
The Human Machine Interface (HMI) uses software which can be controlled through the
Touchscreen on the HMI or remotely using a Programmable Logic Controller (PLC). This
section describes the functions available through the HMI software.
Software Map
The software used to control the LX-150 has four main screens: Other, Manual, Setting, and
Work. Below is a map showing the organization of the software. In the digital version of this
User Guide, each screen name in the map links to a section explaining the function of the
screen.
Other Screen (p. 80)
Alarm & Message (p. 81)
History Message (p. 82)
Knife Offset (p. 83)
PLC Input 1 >> PLC Input 2 (p. 84) >> PLC Output 1 >> PLC Output 2 (p. 86) >> PLC
I/O Monitor (p. 88)
Parameter Setting (p. 89)
Parameter Setting Screen 1
Cut & Feed Procedure Setting
Product Selection
Scan Jump
Motor Parameter 1: Feed Then Cut
Motor Parameter 2: Cut Then Feed
Infeed Correct
Auto Stop Applicating Wheel
Application Spacing Setting
Parameter Setting Screen 2
Timing Screw Setting
Application Fail Setting
Auto Test
Change Password
Parameter Setting Screen 3