Safety 13
4510001 REV B - 220620
Safety
When installing, operating, and maintaining the LX-150 Shrink Sleeve Label Applicator, follow
these safety practices.
Warnings
• Study this User Guide thoroughly before operating the LX-150. Failure to do so may
result in serious injury, damage to the machine, and/or may void the warranty.
• When unpacking and setting up the LX-150, use proper lifting and safety practices.
Avoid overreaching and leaning over. Use at least four persons and a Forklift to lift and
move the machine.
• While installing, maintaining and operating the LX-150, always wear proper safety
clothing, including Safety Shoes and Cut-Resistant Work Gloves.
• Do not locate the machine on an uneven surface, as the machine could tip over.
• Ensure that the electrical power source is properly wired and grounded. The power
source should comply with all safety regulations and codes applicable to the installation
location.
• Never remove any ground connection from this equipment. Failure to follow these
instructions may result in damage to the equipment, fire, serious personal injury, or
death.
• Before turning on the LX-150, always ensure that:
o All necessary accessories are properly connected
o All Rollers spin smoothly without obstruction
o The Conveyor Belt is free of obstruction and operating properly
o The path for the label film, including the Mandrel, is clean and free of obstruction
o Tools or other objects have not been placed where they can accidentally fall/roll
into the machine
o The E-Stop (Emergency Stop) Button is not pushed in
• Only open the Safety Doors after the machine has stopped. Failure to follow these
instructions can damage the machine and void the warranty.
• The Cutter Blades are extremely sharp. Keep hands and tools away from them when the
machine is plugged in, and exercise extreme caution around them even when they are
not moving. Wear Cut-Resistant Work Gloves.
• Always stop the LX-150 before performing any adjustments or maintenance. If the
maintenance procedure does not require the machine to be powered (for example,
changing Cutter Assemblies does not require electricity), unplug the machine as well.
To Next Page