148 Maintenance
4510001 REV B – 220620
Frequency Procedure
Page That
Describes
Procedure
Every 6
Months
Check for wear on the Film Drive Wheels and clean or replace them if
needed.
176
Every Year
Grease the Shafts of the Head Height Adjust. 172
Grease the Shafts of the Applicator Wheel Vertical Adjust. 173
Grease the Shafts of the Film Drive Wheel Adjusts. 176
Grease the Shafts of the Support Wheel Adjusts. 177
Clean the Electronics Cabinet. 181
(To be done
by in-house
Technician or
call
Distributor)
Replace the Support Bearings inside the Mandrel.
157
Replace the Film Drive Bearings inside the Mandrel. 157
Replace the Applicator Bearings inside the Mandrel. 157
Replace the Support Wheels (Part Number: 4500183). 177
Replace the Film Drive Wheels (Part Number: 4500704). 176
Replace the Applicator Wheels (Part Number: 4500128). 178
Replace the Cutter Bearings. 169
Every 2-3
Years
Replace the Film Feed Drive Belt. Call
Distributor
Replace the Idler Bearings. Call
Distributor
Replace the Applicator Drive Belts. Call
Distributor
Replace the Linear Bearings on the Dancer Assembly. Call
Distributor
Replace the Timing Belt
Small: (Part Number: 4501171)
Medium: (Part Number: 4501707)
Large: (Part Number: 4501697)
166
Replace the Cutter Drive Belt (Part Number: 4502129). 165
To Next Page