Agilent Technologies 1200 Infinity Series User Manual

Agilent 1200 Infinity Series DAD User Manual 233
LAN Configuration
13
Dynamic Host Configuration Protocol (DHCP)
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. Agilent ChemStation, LabAdvisor,
Firmware Update Tool) and use MAC address as host name, e.g.
0030d3177321.
The LC system should become visible in the control software (see Note in
section “General Information (DHCP)” on page 231).
Tabl e 2 5 LC Modules inclusive 1120/1220 (configuration switch at rear of the instru-
ment)
SW 6 SW 7 SW 8 Initialization Mode
ON OFF OFF DHCP

Agilent Technologies 1200 Infinity Series Specifications

General

Brand	Agilent Technologies
Model	1200 Infinity Series
Category	Security Sensors
Language	English