Agilent Technologies 1200 Infinity Series User Manual

Agilent 1200 Infinity Series DAD User Manual 51
Using the Module
4
Setting up the Detector with Agilent ChemStation
Setting up the Detector with Agilent ChemStation
The setup of the detector is shown with the Agilent ChemStation B.04.02
based on the 1290 Infinity DAD (G4212A). Depending on the controller (e.g.
Agilent Instant Pilot, EZChrom Elite, MassHunter) the screens look different.
For the Instant Pilot refer to “Main Screens of the Detector with Agilent
Instant Pilot (G4208A)” on page 69.
After successful load of the ChemStation, you should see the module as an
active item in the graphical user interface (GUI).
NOTE
This section describes the detector settings only. For information of the Agilent
ChemStation or other Agilent 1260 Infinity/1290 Infinity Series modules refer to the
corresponding documentation or system manual.

Agilent Technologies 1200 Infinity Series Specifications

General

Brand	Agilent Technologies
Model	1200 Infinity Series
Category	Security Sensors
Language	English