In histogram instrument mode (INST:SEL HIST):
CALC[1|2|3|4]:FEED ‘D1|D2|D3|D4|D5|D6|D7|D8’.
CALC[1|2|3|4]:FEED ‘TCAP [1|2|3|4]’.
CALC[1|2|3|4]:FEED ‘W1|W2|W3|W4|W5|W6|W7|W8’.
To select the most recent unfiltered time record for the specified channel, send
CALC[1|2|3|4]:FEED ‘XTIM:VOLT [1|2|3|4]’.
To select the most recent histogram for the specified channel, send CALC[1|2|3|4]:FEED
‘XTIM:VOLT:HIST [1|2|3|4]’.
To select the probability density function for the specified channel, send CALC[1|2|3|4]:FEED
‘XTIM:VOLT:PDF [1|2|3|4]’. The histogram is normalized to unit area.
To select the cumulative density function for the specified channel, send CALC[1|2|3|4]:FEED
‘XTIM:VOLT:CDF [1|2|3|4]’. This shows the probability that a level to a specific level occurred.
In order analysis instrument mode (INST:SEL ORD; Option 1D0), available commands are:
CALC[1|2|3|4]:FEED ‘D1|D2|D3|D4|D5|D6|D7|D8’.
CALC[1|2|3|4]:FEED ‘TCAP [1|2|3|4]’.
CALC[1|2|3|4]:FEED ‘W1|W2|W3|W4|W5|W6|W7|W8’.
CALC[1|2|3|4]:FEED ‘XFR:POW [1|2|3|4]’. Order track must be off (sent with the
ORD:TRAC:STAT OFF command).
CALC[1|2|3|4]:FEED ‘XTIM:VOLT [1|2|3|4]’. Order track must be off (sent with the
ORD:TRAC:STAT OFF command).
CALC[1|2|3|4]:FEED ‘XVOL:VOLT [1,2|1,3|1,4|3,4]’. Order track must be off (sent with the
ORD:TRAC:STAT OFF command). The analyzer must be in 2 channel instrument mode (INPut 2
ON) for selection 1,2. INPut 4 must be ON for selections 1,3 and 1,4. INPut 4 must be ON and
SENse:REFerence must be PAIR for selection 3,4.
To display one of five order tracks, send CALC:FEED ‘XORD:TRAC [1|2|3|4],[1|2|3|4|5]’. The
first parameter specifies the channel. The second parameter specifies the order track. Order track
must be on (sent with the ORD:TRAC:STAT ON command).
To display time versus RPM (which tells you how long the RPM runup or rundown took), send
CALC:FEED ‘XRPM:PROF’. Order track must be on (sent with the ORD: TRAC:STAT ON
command).
CALCulate
6-25
To Next Page
Loading...
