Note You can transfer measurement data from the analyzer with either the TRAC:DATA
command or the CALC:DATA command. However, you can only transfer data to the
analyzer with the TRAC:DATA command.
The CALCulate mnemonic contains an optional trace specifier: [1|2|3|4]. To direct a command to trace
A, omit the specifier or use 1. To direct a command to trace B, use 2; to trace C, use 3; and to trace D,
use 4. Commands that are not trace-specific—the CALC:MATH commands, the CALC:CFIT commands
and the CALC:SYNT commands—ignore the specifier.
CALCulate
6-2
To Next Page
Loading...
