TABLE OF CONTENTS
CHAPTER 1: GPIB Programming with the Agilent 35670A
GPIB Setup .................................................1-2
Configuring the GPIB System ......................................1-2
Quick Verification ............................................1-5
Verification Program ...........................................1-7
How the Agilent 35670A Operates in an GPIB System ..........................1-8
Controller Capabilities ..........................................1-8
GPIB Commands That Require Passing Control to the Agilent 35670A ................1-8
GPIB Interface Capabilities........................................1-9
GPIB Queues in the Agilent 35670A ...................................1-10
Command Synchronization ........................................1-10
Overlapped Commands in the Agilent 35670A .............................1-11
GPIB Commands That Transfer Mixed (ASCII/REAL) Data ......................1-12
Determining Units ............................................1-12
The Agilent 35670A’s Status Registers ..................................1-13
Register Summary ............................................1-13
Status Byte Register Set .........................................1-14
Device State Register Set .........................................1-16
Limit Fail Register Set ..........................................1-17
Questionable Status Register Set .....................................1-18
Questionable Voltage Register Set ....................................1-19
Standard Event Register Set .......................................1-20
Operation Status Register Set.......................................1-22
User Status Register Set .........................................1-24
Agilent 35670A Register Set Summary .................................1-25
SCPI Compliance Information .......................................1-26
Confirmed Commands ..........................................1-27
List of Approved Commands .......................................1-31
List of Instrument Specific Commands..................................1-32
CHAPTER 2: Introduction to the Command Reference
Finding the Right Command ........................................2-3
Command Syntax in the Agilent 35670A .................................2-5
Special Syntactic Elements ........................................2-5
Conventions................................................2-6
Syntax Descriptions............................................2-7
i
To Next Page
Loading...
