CALCulate[1|2|3|4]:MARKer:DTABle:X:SELect[:POINt] command/query
Selects the data table entry.
Command Syntax: CALCulate[1|2|3|4]:MARKer:DTABle:X:SELect[:POINt] <num
-
ber>|<step>|<bound>
<number> ::= a real number (NRf data)
limits: 1:50
<step> ::= UP|DOWN
<bound> ::= MAX|MIN
Example Statements: OUTPUT 711;"Calc:Mark:Dtable:X:Select:Poin 23"
OUTPUT 711;"CALC:MARKER:DTAB:X:SEL 32"
Query Syntax: CALCulate[1|2|3|4]:MARKer:DTABle:X:SELect[:POINt]?
Return Format: Integer
Attribute Summary: Option: not applicable
Synchronization Required: no
Preset State: not applicable
SCPI Compliance: instrument-specific
Description:
This command selects the entry in the data table. Use it to direct the action of the following commands:
CALC:MARK:DTAB:X:CHANGe
CALC:MARK:DTAB:X:DELete
CALC:MARK:DTAB:X:INSert
CALC:MARK:DTAB:X:LABel
CALCulate[1|2|3|4] specifies the data table. Send CALC1 to specify the data table appearing in trace box
A, CALC2 to specify B, CALC3 to specify C, and CALC4 to specify D. If you do not send the optional
specifier, the command defaults to the data table appearing in trace box A.
To display the data table, use the DISPlay[:WINDow[1|2|3|4]]:DTABle[:STATe] command.
CALCulate
6-65
To Next Page
Loading...
Need help?
General
