The following are not affected by this command:
The state of the Power-on Status Clear flag.
The state of all enable and transition registers.
The GPIB input and output queues.
The time and date (SYST:TIME and SYST:DATE).
The GPIB address settings (SYST:COMM:GPIB:ADDR, HCOP:PLOT:ADDR,
HCOP:PRIN:ADDR).
The GPIB controller capability setting.
The default disk selection (MMEM:MSIS).
The serial interface (RS-232-C) parameters (set with SYST:COMM:SERial commands).
Contents of limit and data registers.
Contents of math function and constant registers.
Contents of the RAM disks.
Calibration constants.
Contents of the time capture buffer.
The external keyboard setup.
Common Commands
3-13
To Next Page
Loading...
