110
PATCH MODE
User Guide
GROUPS
Pressing GROUPS shows this screen:
INPUT CHANNEL GROUP ASSIGN allows you to decide which groups the input channels
will be assigned to and any channel may be assigned to any group 1-8. Note, however, that
routing is done in pairs.
NOTE:
Although it is perfectly feasible to route channels to groups in this page, you may find it
easier to use the front panel keys - i.e. press the appropriate GROUP ASSIGN key and then press the
channels you want to assign to that group).
DISK RECORD GROUP ASSIGN allows you to select which groups the 24 disk tracks will be
routed to and any track may be assigned to inputs 1-8. As with the input channels, that
routing is done in pairs. Regarding the NOTE above, you may find it easier to assign disk
tracks to groups in the same way.
FX RTN GROUP ASSIGN allows you to select which groups the internal effects returns will
be routed to. Regarding the NOTE above, you may find it easier to assign disk tracks to
groups in the same way.
NOTE:
You can only route any channel to one group at a time. For example, you cannot route Input
1 to Group 1/2 and Group 3/4.
To Next Page
Loading...
Need help?
General
