139
User Guide
FLANGER
The common parameters for the Flanger effects are:
• Rate (0.1Hz - 10.0Hz) Adjusts the speed of LFO
• Depth (0% - 100%) Adjusts the depth of LFO
• Fdback (0% - 100%) Adjusts the feedback amount
• FB Inv (ON/OFF) Inverses the phase of feedback signals when enabled
MONO FLANGER
This is a typical flanger effect with mono-in and mono-out.
You can adjust the pan setting of the effect sound with the
additional Pan parameter:
• Pan (-60 - +60)
STEREO FLANGER
This is a stereo flanger effect (mono in - stereo out).
You can adjust the width and spread of the stereo im-
age with the additional Width parameter:
• Width (0% - 100%)
XOVER FLANGER
This is a variation of the STEREO FLANGER. The feed-
back from the L/R channels is input to the opposite
channels.
The parameters are the same.
PAN FLANGER
This effect adds an auto panning effect to the mono
flanger.
FLANGER
To Next Page
Loading...
Need help?
General
