215
User Guide
PATCH
The PATCH pages also look slightly different in surround mode.
Because of the absence of GROUP channels these are unavailable as patch sources or destinations.
If a patch configuration is loaded (as part of a project or as a preset) in which GROUP channels are
used as disk record sources or patched to physical outputs the GROUP source will be replaced
with silence.
Information on the patching of surround bus components to DPS24 monitor outputs is shown
in the PATCH OUTPUTS page. This routing is fixed. Surround bus components can addi-
tionally be patched to available ADAT, DIGITAL or AUX outputs.
DIFFERENCES AND LIMITATIONS IN SURROUND MODE
To Next Page
Loading...
Need help?
General
