140
FX PARAMETERS
User Guide
PHASER
The common parameters for the Phaser effects are:
• Rate (0.1Hz - 10.0Hz) Adjusts the speed of LFO
• Depth (0% - 100%) Adjusts the depth of LFO
• Fdback (0% - 100%) Adjusts the feedback amount
MONO PHASER
This is a typical phaser effect with mono-in and mono-out.
You can adjust the pan setting of the effect sound with the
additional Pan parameter:
• Pan (-60 - +60)
STEREO PHASER
This is a stereo phaser effect (mono in - stereo out).
You can adjust the width and spread of the stereo im-
age with the additional Width parameter:
• Width (0% - 100%)
XOVER PHASER
This is a variation of the STEREO PHASER.
The feedback from the L/R channels is input to the
opposite channels.
The parameters are the same.
PAN PHASER
This effect adds an auto panning effect to the mono
phaser effect sound.
To Next Page
Loading...
