191
User Guide
HOW TO PREPARE MATERIAL FOR DISK-AT-ONCE
Assuming you have mixed down all the stereo masters you want to put on your CD, create a
project and, using copy and insert, create your 'playlist' so that all the songs you want to put
on the CD are placed end to end thus:
You could just make your CD from this. However, you will probably want to put track mark-
ers on your CD. This is done using the autolocator. At the start of each track, mark an autolocate
point and give each locator memory names such as shown below:
Those locate points that are prefixed with # will register as track marker points on the CD.
HOW TO PREPARE MATERIAL FOR DISK-AT-ONCE
To Next Page
Loading...
Need help?
General
