48
POWERING UP THE DPS24
User Guide
POWERING UP THE DPS24
Ensuring that you monitor amplifier's master level control is turned down, switch the DPS24
on using the rear panel POWER switch. You will see this screen during power up:
Followed shortly afterwards by this screen:
Once the disk scan has completed, you should see the icons for the installed drive(s) appear
at the bottom of the screen. Typically, these will be the Internal HD and maybe a CD drive (if
the option is installed).
NOTE:
If your LCD appears blank during power up, check to make sure that the LCD CONTRAST
control is not set to minimum. The contrast can be turned down such that the screen can appear
almost completely blank from some viewing angles.
If your DPS24 does not power up as described above - for example, you get an error message
saying "NO DRIVES DETECTED" or your CD drive (if installed) doesn't show up at the
bottom of the screen or whatever - you should contact your Akai Professional dealer or tech-
nical support immediately.
Assuming your DPS24 does power up properly, you should press MAIN (or whichever mode)
you wish to use.
To Next Page
Loading...
Need help?
General
