216
SURROUND MIXING
User Guide
Patch assignments from the INPUT, DISK and FX RETURN channels to the main surround
bus are accessed by pressing the MAIN.BUS key.
RECORD
The main purpose of the surround feature is for mixing, and it is intended to be used after
track laying is complete. As such, recording functionality is limited in surround mode.
The "24 track record" mode is not supported in surround modes.
You can simultaneously record up to 6 independent sources in 5.1 mode or 4 in LCRS and 2+2
mode. This allows you to record a surround stem from an external source while in surround
mode if required or to perform limited track laying once the surround project has been created.
If you try to exceed this limit you will see a message like this:
To Next Page
Loading...
Need help?
General
