Akai DPS 24

136
FX PARAMETERS
User Guide
TAPE ECHO
This delay effect simulates a three-head tape echo machine. You can set three delay times
individually. This effect has mono-in and mono-out; however, you can adjust the pan
setting of the effect sound.
• Head 1 (1ms - 1500ms) Adjusts the Delay time of Head 1.
• Head 2 (1ms - 1500ms) Adjusts the Delay time of Head 2.
• Head 3 (1ms - 1500ms) Adjusts the Delay time of Head 3.
• Fdback (0% - 100%) Adjusts the amount of delay Feedback .
• HFdamp (20Hz - 20kHz) Sets a frequency at which the higher range of the feed-
back sound is cut.
• Pan (-60 - +60) Adjusts the stereo image of the effect sound.
MULTI TAP DELAY
This delay effect creates a special effect by adjusting the interval between feedback sounds
and the level change curve of the feedback sounds.
• Delay (1ms - 1500ms) Adjusts the delay time.
• Width (0% - 100%) Adjusts the width and spread of the stereo image.
• Shape (-10 - +10) Adjusts the interval between the feedback sounds.
• Slope (-10 - +10) Adjusts the attenuation curve of the feedback sound.
• Fdback (0% - 100%) Adjusts the amount of delay feedback.
• Pan (-60 - +60) Adjusts the stereo image of the effect sound.