Parameters for managing the DCC
...................................................................................................................................................................................................................................
Port
Shows the line and tributary ports on which DCC is available. If the port is part of an
MSP scheme running in slave mode, both ports involved with the protection scheme
are shown on the same entry.
DCC channel
Shows which channel the DCC is running over.
DCC status
Shows the current status of the DCC or the slaved pair. Values can be enabled or
disabled. The meaning of these values are described in the table below:
DCC Status Description
Disabled The DCC communication on this port is stopped. No D-bytes
will be exchanged on this port within this network element
and his neighbors.
Enabled This port can be used in DCC communication for exchanging
management data between the network elements.
Important
Maximum 32 DCC channels can be enabled.
Management communication setup
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-43
To Next Page
Loading...
