View or Edit NTU’s General Configuration
...................................................................................................................................................................................................................................
When to use
To view the NTU’s Bridge mode, VLAN, and QoS functionality support
Before you begin
No prerequisites or precautions are needed when performing this procedure.
Procedure
...................................................................................................................................................................................................
1
Select Provisioning —> SHDSL —> Connection/NTU.
Result: The SHDSL Connection List window is displayed.
...................................................................................................................................................................................................
2
Select one SHDSL connection from the list.
...................................................................................................................................................................................................
3
Click Virtual Switch .
Result: The Remote Virtual Switch Information window appears.
...................................................................................................................................................................................................
4
Click Edit.
Result: The Edit Remote Virtual Switch Information window appears.
...................................................................................................................................................................................................
5
In the Remote Virtual Switch Mode, select the appropriate mode and from the drop
down list select None or Strict Policy for
Remote Ingress Rate Control and click Ok.
The Virtual switch modes are:
• Self Learning Bridge
• Vlan Bridge
• Provider Bridge
Result: The window is populated with the new information.
...................................................................................................................................................................................................
6
In Remote Virtual Switch Information window select the port and click on Port
Details
.
Result: The Remote LAN CTP Information window appears.
...................................................................................................................................................................................................
7
Click Edit and provision the CIR, CBS and Default Vlan ID values and click Ok.
...................................................................................................................................................................................................
8
If the Remote Virtual Switch Mode is Vlan Bridge then click Add.
Traffic provisioning
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
8-173
To Next Page
Loading...
