Provision static MAC address table
...................................................................................................................................................................................................................................
When to use
This procedure is used to provision the static MAC address table.
Note: The Provision static MAC address table procedure is also applicable to X5IP.
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• “Provisioning a virtual switch in spanning tree mode” (p. 8-105)
• Cross connection should be enabled “Provision cross connections without
protection” (p. 8-147) and VCG should be set to monitored.
Provisioning the static MAC address table
...................................................................................................................................................................................................
1
Select Provisioning → LAN Management → Virtual Switch.
Result: The Virtual Switch List window appears.
...................................................................................................................................................................................................
2
Select the Physical Switch and Virtual Switch.
...................................................................................................................................................................................................
3
Click Static MAC Table.
Result: The Static MAC Address Table appears.
In the Static MAC Address List the following is displayed for each list entry:
• The MAC Address
• The VLAN ID
• The Multicast Group ID
• The Out Port.
...................................................................................................................................................................................................
4
The following actions can only be performed when the static MAC address table is
activated.
If you want to THEN
activate the static MAC address table, click
Enable.
deactivate the static MAC address table, click Disable.
When deactivating a static MAC address
table, a warning screen is displayed,
indicating that all manual provisioned
functions and all related configurations
will be lost.
Traffic provisioning
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
8-123
To Next Page
Loading...
