Adding a remote accessible NE to the configured nodes list
...................................................................................................................................................................................................................................
Remote login is the possibility to connect via the local network element to another
network element in the network. It can be used to configure network elements without
actually having to go to the physical location of the network element.
When to use
Use this procedure to add remote assessable network elements to the configured nodes
list. By selecting the node added to the configured nodes list a remote login can be
established.
Related information
Remote login by using the Configured Nodes list.
Refer to “Concepts” (p. 4-3).
Before you begin
Pay attention to the following:
• When an already specified NSAP is used an error message will be displayed, and
upon the user selecting OK, then will be prompted to re-enter the NSAP value.
• when an incorrect NSAP is specified for example if the characters are not
hexadecimal characters an error message will be displayed, and upon the user
selecting OK, then will be prompted to re-enter the NSAP value.
Procedure
Follow this procedure to add remote logins to the configured nodes list:
...................................................................................................................................................................................................
1
Login to the network element to which the ITM-CIT is physically connected.
Result: A connection is established.
...................................................................................................................................................................................................
2
Select File —> NE Login –> Login.
Result: The NE login window appears.
...................................................................................................................................................................................................
3
Click Add.
Result: The Add Accessible Network Element window appears.
...................................................................................................................................................................................................
4
Select Add NE Manually and fill in:
• NE Name (user defined).
• NE NSAP (fixed 20 bytes).
• Comment (user defined, optional).
Management communication setup
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-47
To Next Page
Loading...
