Changing the inactivity time
...................................................................................................................................................................................................................................
When to use
Use this procedure to change the inactivity time, and by specifying after which time a
user will be logged out do not do any action with CIT. If the value is 0, the user will
never be logged out.
Related information
A related procedure is viewing access control parameters.
Before you begin
Changing of the lock state can only be done when logged in as administrator.
Procedure
Follow this procedure to change the inactivity time:
...................................................................................................................................................................................................
1
Select Management --> Access Control --> Access Control Parameters.
Result: The Access Control Parameters window appears.
...................................................................................................................................................................................................
2
Click on the capability that needs to be edited. If there are more users than can fit in
the window, click on the scroll buttons (the arrow button) and scroll to the desired
user.
...................................................................................................................................................................................................
3
Click Edit.
Result: The Edit Access Control Parameters window appears.
...................................................................................................................................................................................................
4
Change the Inactivity time. This can be done by deleting the old time and filling in a
new time. It can also be changed by clicking on the increase or decrease button (the
arrow buttons). Click
OK to set the changes.
Result: The Access Control Parameters window reappears.
...................................................................................................................................................................................................
5
Click Close.
Result: The Access Control Parameters window disappears.
E ND OF STEPS
...................................................................................................................................................................................................
Security administration
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
3-9
To Next Page
Loading...
