Provision Quality of Service (QoS)
Overview
...................................................................................................................................................................................................................................
Purpose
Quality of Service is supported on the TransLAN
®
tributary board and the Gigabit
Ethernet card. It is implemented as a DiffServ architecture applied to layer 2.
QoS control allows to differentiate between Ethernet frames with different priorities. If
traffic with a high priority and traffic with a low priority compete for SDH capacity,
the traffic with the high priority should be served first. This can be realized through
QoS control.
References
“Quality of Service (QoS) overview” (p. 8-81)
Contents
Provision the QoS profile definitions 8-130
Parameters for provisioning a QoS profile 8-131
View QoS profile information 8-134
View the details of a LAN/WAN port QoS parameters 8-135
Edit QoS mode 8-136
Provision QoS Flow Identification Table 8-138
Parameters for provisioning Flow Identification Tables 8-141
Edit the QoS egress details 8-145
Ingress rate control 8-146
Traffic provisioning
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
8-129
To Next Page
Loading...
