Editing provisioned IP parameters
...................................................................................................................................................................................................................................
When to use
Use this section to provision or change the NE tunnel information.
Related information
“Concepts” (p. 4-3).
Before you begin
Before changing provisioned NE tunnel information a network plan must be available.
Procedure
Complete the following procedure to edit the Local IP Parameters.
...................................................................................................................................................................................................
1
Select Management --> Data Comm Interface.
Result: The Datacom Interface Information window appears.
...................................................................................................................................................................................................
2
Click Edit.
Result: The Edit Datacom Interface Information window appears.
...................................................................................................................................................................................................
3
Make the changes as desired.
Result: The desired values are selected.
...................................................................................................................................................................................................
4
Click OK to confirm the current settings.
Result: A pop up window will appear with the message: “The local IP
configuration (IP address and/or subnetwork mask) has updated. This will cause
the NE to restart and will result in the loss of ITM-CIT session. Do you wish to
continue?”.
...................................................................................................................................................................................................
5
Click OK to proceed with the operation.
...................................................................................................................................................................................................
6
Click Close to finish the activities in this window.
E ND OF STEPS
...................................................................................................................................................................................................
Management communication setup
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-59
To Next Page
Loading...
