Alcatel-Lucent 1643 AMS - Remote Login Via Area Option

Remote login via Area option
...................................................................................................................................................................................................................................
Remote login is the possibility to connect via the local network element to another
network element in the network. It can be used to configure network elements without
actually having to go to the physical location of the network element.
When to use
Use this procedure to make a remote login to a network element that is in the same
area as the local network element to which the CIT is physically connected. This
makes it possible to perform a remote login without having to fill in the NSAP address
of these nodes.
Related information
Related procedures are:
• Managing the DCC
• Adding remote logins to the configured nodes list
• Remote login via configured nodes list
• Remote login via Neighbors option
• “Concepts” (p. 4-3).
Before you begin
It is only possible to set up a remote session if no other remote session already exists.
Procedure
Follow these steps to perform a remote login by using the area option:
...................................................................................................................................................................................................
1
Login to the network element to which the ITM-CIT is physically connected.
Result: A connection is established.
...................................................................................................................................................................................................
2
Select File —> NE Login –> Login.
Result: The NE login window appears.
...................................................................................................................................................................................................
3
Click Area.
Result: The Network Area Members List window appears, displaying all network
elements in the same area as the local network element.
...................................................................................................................................................................................................
4
Select the NSAP address of the network element to login to. Then click Login.
Management communication setup
...................................................................................................................................................................................................................................
4-56
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007