Remote login via neighbors option
...................................................................................................................................................................................................................................
Remote login is the possibility to connect via the local network element to another
network element in the network. It can be used to configure network elements without
actually having to go to the physical location of the network element.
When to use
Use the following procedure to perform a remote login by using the neighbors option.
With this option all neighboring nodes, from the network element to which the
ITM-CIT is physically connected, are identified. This makes it possible to perform a
remote login without having to fill in the NSAP address of these neighboring nodes.
Related information
Related procedures and information are:
• Managing the DCC
• Adding remote logins to the configured nodes list
• Remote login via configured nodes list
• Remote login via area option
• “Concepts” (p. 4-3).
Before you begin
It is only possible to set up a remote session if no other remote session already exists.
Procedure
Follow this procedure to perform a Remote login by using the neighbors option:
...................................................................................................................................................................................................
1
Login to the network element to which the ITM-CIT is physically connected.
Result: A connection is established.
...................................................................................................................................................................................................
2
Select File —> NE Login –> Login.
Result: The NE login window appears.
...................................................................................................................................................................................................
3
Click Neighbours.
Result: The DCC Neighbours List Filter window appears.
...................................................................................................................................................................................................
4
Select which slot and port are to be used to find any neighboring connected NEs. Then
click
OK.
Management communication setup
...................................................................................................................................................................................................................................
4-54
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
