Parameters of the window “View SDH Channel / VCG
Information”
...................................................................................................................................................................................................................................
Fields and parameters
The following table shows the status data which are shown in the View SDH Channel
/ VCG Information
window.
Information field Meaning
Physical Switch
Displays the physical switch.
SDH Channel / VCG Displays the name of the SDH channel termination point
TP mode Displays the current SDH Channel Monitoring mode of each Termination Point
individually.
Encapsulation Mode Displays the encapsulation mode
LCAS Mode Displays if LCAS is either enabled or disabled.
Hold Off Time (s) Displays the hold off timer
WtR Time (min) Displays the global WtR timer for LCAS
Capacity
Provisioned (Source)
Displays the provisioned source WAN port capacity
Provisioned (Sink) Displays the provisioned sink WAN port capacity
Working (Source) Displays the source working capacity
Working (Sink) Displays the sink working capacity
Associated VC (Display VC information in the VCG)
Name Displays the name of the VC TP
VC Type Displays the type of the VC resource
Source Status Displays the status of the VC resource.
Sink Status Displays the status of the VC resource.
Relative Differential
Delay (ms) Shows the relative differential delay of the VCG Tribs in ms. The fastest trib has a
delay of 0 ms. The delay of the other tribs is relative to the fastest one.
Refer also to “Differential delay” (p. 8-42)
Traffic provisioning
...................................................................................................................................................................................................................................
8-102
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007
To Next Page
Loading...
